Arris Touchstone TM508 Guide d'installation télécharger pdf (Page 32)

Touchstone Telephony Release 5 Standard 1.2 Mar 2007

• To mount the power supply on drywall, you need two drywall

anchors.

• To mount the power supply on plywood, you need two 1-inch

#6 wood screws.

CAUTION

Risk of equipment damage

Connect only DC or AC power, not both, to the TM512. Connecting

both supplies may cause a reset upon loss of AC power.

Action Perform the following tasks in the order shown.

Task Page

Mounting the Power Supply ..................................................22

Connecting the Cables ...........................................................23

Mounting the

Power Supply

Follow these steps to mount the power supply.

1 Remove the battery from the power supply and set the battery aside.

2 Place the power supply on the mounting surface at the desired loca-

tion. Mark the ends of the keyhole slots. The following diagram

shows the locations of the keyhole slots.

3 After marking the mounting slot location, set the power supply

aside.

Keyhole Slots

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Pas de commentaire

Arris Touchstone TM508 Guide d'installation Page 32