Arris Touchstone CM550 Guide de l'utilisateur télécharger pdf (Page 15)

Home Prev Next Touchstone CM550 Cable Modem User’s Guide 15

Safety Getting Started Installation USB Drivers Usage Troubleshooting Glossary

Instructions

Wall-mounting instructions

Position the mounting template on the surface where you intend to mount

the Cable Modem and secure in place with transparent tape.

Drill holes through the template in the specified locations for the mounting

screws. After drilling holes, remove the template from the surface.

Drive both of the screws (or anchor bolts) into the wall. Leave a gap of about

6 mm (0.250 inches) between the screw head and the wall.

Orient the Cable Modem with the indicator lights facing up or right, as de-

sired. Slip both mounting slots (in the back of the Cable Modem) over the

screws, then slide the case down until the narrow end of the keyhole slot

contacts the screw shaft.

Proceed to Connecting the Cable Modem

Desktop mounting instructions

Position the Cable Modem so that:

•air flows freely around it

•the back faces the nearest wall

• it will not fall to the floor if bumped or moved

If you want to stand the Cable Modem up on its side, pull the oval foot out

slightly, twist the foot (as shown), and place the Cable Modem in the desired

location.

Proceed to Connecting the Cable Modem.

Step 1 Step 2

Step 3 Step 4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

Arris Touchstone CM550 Guide de l'utilisateur Page 15